As we know, the smoke as well as dust which are produced by the engraving as well as cutting will certainly damage the guide rail after a period of use, so we have to do the day to day upkeep of the overview rail. Please turn off the laser engraving machine and reduced the power, clean the guide rail with tidy weigh, after that please drop the lubricating oil on the overview rail, attempt to relocate the slide rod and also see to it that the oil enters it. Make the slide rod move on the guide rail after filling up the oil, currently we have to install the overview rail to start with, please do not fix the guide rail first of all, install the screws in the appropriate position and keep the slide ray on the even degree. After that repair the belt and also slide rod well, install the lens and then readjust the location of X light.
After a duration of use of the laser engraving as well as laser cutting machine, the smoke and also dirt will certainly follow the surface of the reflector and also mirror, which will certainly affect the engraving and cutting depth and will affect the engraving and also cutting accuracy. We need to clean up the three reflectors as well as one focusing mirror with pure alcohol weekly. A laser engraving machine is equipped with great deals of bearings, in order to keep the excellent engraving and cutting result, part of bearings have to be re filled with oil regularly except the oil retaining bearing. Rub out the surface area dust on the bearing with the tidy mull, take a piece of injector and also suck some engine oil inside, then load the bearing with pinhead and move the bearing at the very same time.
There are some simultaneous belts on one laser engraving makers, if the synchronous belt is as well loosened which will cause the double images of the engraved words, if the synchronous belt is as well limited which will lead to the abrasion of simultaneous belt. After a duration of usage, please readjust the tight screws of simultaneous belt, readjust the concurrent belt until its degree of tightness is suitable, it suffices when there is no double images of the personalized words and the sound of the laser engraving and also is really reduced, or you can consult our service technician. The دستگاه برش لیزری طلا of the laser engraving machine is using the cycle water as cooling system and also as the time takes place, there will certainly be some furring’s inside the laser tube. We can put a little vinegar right into the cycle water; the vinegar will thaw the furring. Afterwards, we will utilize some clean water to clean television. So the laser tube will certainly remain in the most effective working condition and also its life will become longer.